Roof repair is not a project to be taken lightly. Severe weather conditions like high winds, hail, and falling debris can cause serious damage to your home.

Getting up in the attic or crawl space and inspecting your roof is essential to spot issues. Look for damp stains, mold growth, and damaged fascia boards. Visit our Website to learn more.

Rain or snow can cause water damage in several ways. A sudden flood in a basement during a thunderstorm, a burst pipe, or even just water that slowly seeps through drywall can all damage your home. However, water damage from the roof is one of the most common and often hardest to identify. Fortunately, there are a few key signs that you can look for to help you determine whether or not you need roofing repair after a storm.

Water spots and stains on ceilings are often the first indicator of storm damage. If you notice these stains, it’s important to inspect the ceiling and attic to find out what caused them. Water spots and stains are most likely caused by excess moisture that seeps through the drywall above your ceiling. Over time, this can lead to rot or mildew. If left untreated, this can cause more serious issues such as water spots and mold in other rooms.

Cracked shingles and dislodged flashing can also cause leaks. These can occur if a nail isn’t driven in far enough or is driven in sideways. When this happens, the head of the nail will work its way back up through the shingle. Rainwater can then seep through this crack and make its way into the attic or home.

Clogged gutters can also lead to water damage. Leaves, twigs and debris can build up in gutters, blocking them and preventing rainwater from draining properly. Over time, this can cause rotting fascia boards and attic damage. Regular gutter cleaning and maintenance can prevent this problem.

Pipe boot problems are another common source of leaks. The rubber seals around pipes protruding from the roof can degrade over time due to weather and sun exposure. When this occurs, the boots can allow water to seep through and into the attic or home. Replacing pipe boots and applying sealing caulk to the areas surrounding them can prevent leaks.

Water damage from a leaky roof can be extremely expensive. By identifying and repairing these problems promptly, you can minimize the cost of repairs and avoid unnecessary damage to your home.

Rain or snow causes roof leaks that can seep into homes and cause a variety of problems from water damage to mold and rot. Water damage from a leaking roof can be very expensive and often isn’t covered by homeowners insurance. The best way to avoid this is to have your roof inspected regularly by a professional.

If you suspect a leak, the first thing to do is check to see whether it’s still raining or there’s a heavy layer of melting snow on the ground. If it is, then the leak will most likely have moved from its original location and can be difficult to find. If it’s not, then the leak will most likely be in a specific area and much easier to pinpoint.

The most common cause of a leak is damaged or dislodged flashing. Residential roofs have flashing to help direct rainwater away from seams, and it’s very important that these pieces of metal don’t get loose or become dislodged. When this happens, rainwater can infiltrate the home and ruin ceilings and walls.

Another source of a leak is cracked or missing shingles. This problem is easily preventable by having regular roofing inspections and repairing any cracks or holes before they become serious leaks.

Leaks can also be caused by chimney leaks, roof vents, and cracked or leaking window and door frames. Leaks can occur in bathrooms if there’s not enough ventilation, especially when showering. Leaks in these areas can be caused by not using the fan while showering, not removing the old vent, or by having an improperly installed bathroom fan.

To test for a leak, you can put a bucket or tarp underneath the area where the water is coming from. Then, go up into the attic or crawlspace and use a flashlight to look for water stains or black marks on the ceiling. If there is a spot that seems to be getting bigger, or if it gets worse after a rainstorm, then you have a roof leak and need a repair.

A few shingles that have blown off your roof may not seem like a big deal, but a large enough amount can allow water to get in and damage the underlayment and other areas of your roof. This can lead to leaks that you’ll have to repair later. The best way to prevent this is by catching the problem early and replacing the damaged shingles.

To do this, you’ll need a flat pry bar, asphalt roofing cement, replacement shingles, and roofing nails. Before you begin, tie a length of rope to a sturdy object on the side of your house opposite where you’ll be working. Route this rope over the peak of the roof, then climb onto your roof with a ladder. Be sure to use a safety harness and have a friend help you secure the ladder at the base of the roof.

Once you’re on the roof, find the shingle that needs replacement and locate the damage. This might be a crease or flip (when the shingle tab bends up and over the shingle above), a tear, or a puncture. Once you have this information, loosen the roofing nails that hold the shingle in place with your flat pry bar and remove it.

You should also check the underside of the shingle for any signs of moisture damage. Moisture can cause the granules on top of the shingle to deteriorate, leaving them exposed. This deterioration can lead to corrosion, which will eventually eat through the shingle. To avoid this, reseal the underside of the shingles with roofing cement.

When you’re ready to replace the shingle, start with the row immediately above the damaged one. Loosen the roofing nails on this shingle by sliding your pry bar under it, then pull up. Next, carefully lift each surrounding shingle about a foot off to the side of the damaged shingle and remove it. Continue doing this around the perimeter of the damaged shingle, being careful not to break or crack the other shingles.

Once the area is clear, lay down the new shingle and fasten it with roofing nails. If you have any gaps or holes, fill them with a dab of roofing cement and press down firmly to ensure that it adheres. Then, sprinkle the granules that were on top of the old shingle into the gap to camouflage the repairs.

A gutter system’s primary job is to funnel rainwater away from your roof and the foundation of your house, protecting these areas from damage and potential flooding. However, sometimes gutters get damaged for various reasons. The good news is that gutter repair may be covered by homeowners insurance.

Gutters that are clogged with leaves or other debris block the flow of water. When this occurs, water that would normally drain off the roof and away from the house begins to pool and erode the foundation of your home. This can lead to costly foundation repairs and basement flooding if left unchecked.

In addition, a clogged gutter can also rot fascia boards and expose wooden window sills, doors and woodwork to high moisture content. These conditions are ideal for the growth of mold and mildew, which is a serious health concern for your family and can cause structural problems for your home.

Cracks in walls and ceilings are another common sign of a faulty gutter. When water pools behind a gutter, it can erode the wall or ceiling and create a gap. This is often caused by a clogged gutter that blocks the natural flow of rainwater or by the pressure of heavy snowfall.

Other forms of gutter damage include rust spots and holes. A rust spot or hole in the gutter is often caused by metal corrosion and can be easily repaired with roofing cement. However, a gutter that has been punctured by tree branches or falling debris is likely beyond repair and will need to be replaced.

If your gutters are damaged by wind or falling tree branches, it is important to contact your homeowners insurance company as soon as possible. Your policy will likely cover the cost of repairing or replacing your gutters up to a certain dollar amount, which can help protect you from costly out-of-pocket expenses. In some cases, your home restoration contractor will be able to file a claim with the insurance company on your behalf. Make sure to document all damage, including stained walls and wet ceilings, with photographs and videos as well as water-damaged furnishings and personal items.